Icom IC-M73 Plus User Manual Page 45

  • Download
  • Add to my manuals
  • Print
  • Page
    / 56
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 44
New2001
37
12
TROUBLESHOOTING
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
PROBLEM POSSIBLE CAUSE SOLUTION REF.
The transceiver does not
turn ON.
• The battery is depleted.
• Bad connection to the battery pack.
• Recharge the battery pack.
• Check the connection to the transceiver.
pp. 33,
34
p. 3
No sound from the
speaker.
• Squelch level is too tight.
• Volume level is too low.
• Speaker has been exposed to water.
• Water has entered to [SP MIC] connector.
• Set squelch to the threshold point.
• Rotate [VOL] to set a suitable level.
Hold down [F] to drain water from the speaker.
• Dry [SP MIC] connector.
p. 13
p. 11
p. 13
Transmitting is
impossible, or high
power can not be
selected.
Some channels are for low power or
receive only.
• The battery is exhausted.
• The battery is overcharged.
• The output power is set to low.
• The transceiver is over heated.
• Change channels.
• Recharge the battery pack.
• Verify the battery voltage is correct.
• Push [H/L•LOCK] to select high power.
Turn OFF the power, leave it at room temperature
for a while.
pp.
11, 12,
40–42
pp. 33,
34
p. 11
The displayed channel
cannot be changed.
• Lock function is activated. Push [H/L•LOCK] for 1 second to cancel the
function.
p. 12
Scan does not start.
Favorite (TAG) channels are not
programmed.
• Set the desired channels as “Favorite (TAG)”
channels.
p. 15
No beeps. • Beep tones are turned OFF. Set the beep tones to ON (Fix Beep/Preset) in the
SET mode.
p. 26
Does not record or does
not record properly.
The read/write capacity has been
exceeded (the recording counter displays
100 or more. (p. 4)), or the memory is
damaged.
• The memory IC should be replaced.
Ask your technical dealer for service.
The weak signal is
not recorded by the
automatic recording
function.
The automatic recording threshold level
is too deep.
Set the automatic recording threshold level to
shallow.
p. 30
“CHARGE” comment
blinks
• The connected battery is depleted. • Recharge the battery pack. pp. 33,
34
Page view 44
1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 55 56

Comments to this Manuals

No comments